3
GB | Wireless Weather Station
Specifications:
backlit display
radio controlled clock
indoor temperature: -5 °C to +50 °C
outdoor temperature: -20 °C to +60 °C
temperature resolution: 0.1 °C
indoor temperature measurement accuracy:
±2 °C (-5 to 0 °C), ±1 °C (0 to 40 °C), ±2 °C (41 to 50 °C)
outdoor temperature measurement accuracy:
±2 °C (-20 to 0 °C), ±1 °C (1 to 30 °C), ±2 °C (31 to 60 °C)
indoor humidity: 10 to 99 % RH
outdoor humidity: 20 to 90 % RH
humidity resolution: 1 % RH
indoor humidity measurement accuracy:
±5 % RH (40 to 70 % RH), otherwise ±8 %
outdoor humidity measurement accuracy:
±6 % (41 to 70 % RV), otherwise ±8 %
wireless sensor: transmission frequency 433 MHz
radio signal range: up to 30 m in an open area
number of sensors for connection: max. 3
outdoor temperature detection cycle: approx. every
60 seconds
power supply:
main unit: 1× 3 V CR2032 battery (included),
4.5 V DC/300 mA adapter (included)
sensor: 2× 1.5 V AA batteries (not included)
dimensions and weight without batteries:
main unit: 139 × 109 × 59,5 mm, 319 g
sensor: 65 × 100 × 35 mm, 75 g
Description of the weather station
(see Fig. 1)
A – Weather forecast
B – Clock
C – Alarm
D – Icon of DCF signal/DST
E – Indicator of signal reception from the sensor
F – Sensor number 1/2/3
G – Outdoor temperature
H – Outdoor humidity
CH – Indoor humidity
I – Indoor temperature
J – Compartment for back-up battery - 1× 3 V CR2032
1 – ALARM button
2 – CHANNEL button
3 – MAX/MIN button
4 – TIME button
5 – HISTORY button
6 – LOOP button
7 – RAINBOW button
8 – TUNE button
9 – SENSOR button
10 – RCC button (reception of DCF signal)
11 – OUTDOOR TEMP button
12 – RESET button
13 – °C/°F button
14 – OFF-LO-HI button
15 – connector for connecting 4.5 V adapter
16 – indoor temperature and humidity sensor
17 – SNOOZE button
Sensor description
(see Fig. 2)
1 – sensor LED
2 – sensor display (sensor number, temperature and
humidity)
3 – RESET button
4 – hole to hang the sensor on the wall
5 – sensor channel number switch
6 – battery compartment
Getting Started
1. Insert the battery in the weather station (1× 3 V CR2032), connect the included 4.5 V DC adapter. The CR2032 battery is
only intended as a backup power source for storing the readings when the DC adapter is disconnected.
It is therefore necessary to use the DC adapter at all times.
2. Use the switch on the sensor to set the required sensor number and insert the batteries (2× 1.5 V AA). When inserting
the batteries, make sure polarity is correct to avoid damaging the weather station or sensor. Only use alkaline batteries
of the same type, do not use rechargeable batteries.
17
I
J
1
9
2
10
3
11
4
12
5
13
6 7 8
14
15
16
A
B
C D
CH
H
G
E
F