emitor SATLOOK Mark III DiSEqC, Руководство пользователя

Страница: 5 / 10

B. Batterycheck.
As the instrument has been stored for some time before transportation it is important to check
the battery-condition.
To do this turn the mainswitch On.
When starting the instrument, the monitor turns on in spectrum-mode and LED nr 2 on the
front-display will be lit. The two digit LED-display indicates "SP" for spectrum.
The loudspeaker is switched off when the instrument is turned on.
Push the No 6 button on the keypad to read the battery condition. The condition is indicated on
the two digit LED-display with a value between LO, 1-9, HI.
If the battery needs recharging, use the power-supply enclosed.
NOTE, The instrument should be turned off when the battery is recharged.
The two digit LED-display (automatically turned on when recharging) shows "CH", for
charging, while recharging.
Recharging from discharged battery to about 85% capacity takes aprox.3 hours.
C. Connection and installing a satellite dish.
When the battery is charged the instrument is ready to use.
Connection of coaxial-cable and LNB is preferably done when the instrument is turned off. In
case of connecting when the instrument is On and if a short-circuit occur, it's no harm done due
to the fact that the instrument is protected against such a failure and will automatically turn off
itself.
After correcting the problem, restart the instrument and it will operate normally.
The instrument starts in the spectrum-mode which makes it easy to detect the satellite/s You're
looking for. If You want to switch on the loudspeaker function (beeper), press the No 8 button
(on/off).
When a satellite is received, the monitor immediately show "peaks" which are getting bigger
when the signal is increasing.
If the loudspeaker (beeper function, button nr 8) is switched On there are higher and higher
tones when the signal level is getting stronger.
Audio carriers can be tuned in when pushing button nr #. The two small knobs below the
keypad adjust the volume and the audio-frequency between 5.5 and 8.5 MHz.
Both the beeper- and the audio- function can be operational at the same time.
If You want to see what satellite You're receiving, change to picture-mode with
button No 1.
It is advisable that You, before switching between spectrum and picture, use the knob on the
side of the instrument which controls the marker on the monitor. Put the marker on a suitable
peak and switch to picture with button No 1.
As there are different transmission standards and coding systems etc. it is not certain that a
satellite immediately can be identified. Push button No 4 and use the knob for tuning in the
frequency-range and try to find a certain channel for identification.