Eminent ET-II, Руководство пользователя

Страница: 8 / 26

In order to install the kit you must first remove the counterweight assembly from the
backside of the air bearing spindle. This is done by loosening the top screw on the counterweight
clamp. Loosen this screw about one full turn and pull the clamp off of the end of the spindle. Do
not overtorque these screws when re-assembling this part. The 3/32” allen wrench which is
supplied with the ET-2 is the only tool required for installation.
After the counterweight clamp is removed from the air bearing spindle you must remove
the I-beam from the clamp. This is also done by removing the clamp cover screw and pulling
outward on the I-beam. The I-beam should pull out exposing a stainless steel fork spring on its
end.