manualshive.com logo in svg

EMG RETRO ACTIVE Series, Информация по установке, Страница: 4 / 4

Поделиться
Скачать
EMG RETRO ACTIVE Series Скачать руководство пользователя страница 4

Battery Replacement:

Remove these 4 screws, 

gently lift the pickguard’ 

remove and replace the battery.

Step Eight:

This completes the installation. Plug the battery clip onto the battery.

We suggest you plug in the instrument, tap lightly on the pickups with 

a small screwdriver to make sure the pickups are working correctly. 

When the battery needs to be replaced (about 6 months to 1 year) 

refer to the diagram at the right.  

Retro Active S/S/S COMBINATION SYSTEM INSTRUCTIONS Page 4

Step Six:

1) Plug the Output Cable from the PC Board (GND/SIG) to the Volume Control.

2) Plug the Output cable from the Output Jack onto the Volume control as shown.

3) Plug the green wire onto the Ring terminal of the Switch PC Board. 

Step Seven:

Plug the Battery clip cable onto the BAT- (BLACK) and the BAT+ (RED)

terminals of the PC Board. 

OUTPUT CABLE TO THE VOLUME CONTROL

GREEN WIRE TO THE RING 

TERMINAL PIN OF THE PC BOARD

FROM 

OUTPUT JACK

BATTERY CLIP TO BAT- AND BAT+

TERMINALS ON THE PC BOARD 

-  9V  +

Содержание RETRO ACTIVE Series

Страница 1: ...ted into the jack If you are replacing passive pickups make sure to use the jack included If your guitar has a long panel jack make sure it is a stereo type a Switchcraft 152B is recommended 4 When installing EMG Active Pickups DO NOT connect the bridge ground wire This wire is usually soldered to a volume or tone control casing and goes to the bridge This wire grounds the strings and uses them an...

Страница 2: ...jack will be required see the Power Tips Data sheet at http www emgpickups com 2 Some instruments may already have a battery holder installed and in that case soldering may be required see page 3 Installing EMG Combination Systems is very easy and is accomplished in a few steps The controls included have a 10 mm bushing height so they can be used either on a pickguard or body mount The cable lengt...

Страница 3: ...nting down Refer to the diagrams below and make sure the Jack is mounted tightly Step Five Route the Output cable from the Jack cavity into the control cavity via the small hole If the hole is too small Push the connectors through one at a time Fasten the Jack plate onto the guitar and test to make sure the cable inserts and exits easily Mount the battery in the control compartment Insulate the ba...

Страница 4: ...r refer to the diagram at the right Retro Active S S S COMBINATION SYSTEM INSTRUCTIONS Page 4 Step Six 1 Plug the Output Cable from the PC Board GND SIG to the Volume Control 2 Plug the Output cable from the Output Jack onto the Volume control as shown 3 Plug the green wire onto the Ring terminal of the Switch PC Board Step Seven Plug the Battery clip cable onto the BAT BLACK and the BAT RED termi...

Отзывы:

Нет отзывов