Dimensions:
Pi2
SPECIFICATIONS
Input Impedance (Ohms)
250K
Input Referred Noise
-130dbV
Internal Gain
2.5db
Output Impedance (Ohms)
2K
Current @ 9V (Microamps)
980
Battery Life (Hours)
250
Maximum Supply (Volts DC)
18
INSTALLATION INFORMATION
EMG MODELS:
Pi2 PHASE INVERTER
(ACTIVE/PASSIVE PICKUP INPUTS)
Warranty
All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If
upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This
warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.
© 2010 Copyright EMG INC. All Rights Reserved.
PO BOX 4394
SANTA ROSA, CA
95402 USA
P (707) 525-9941
F (707) 575-7046
EMGPICKUPS.COM
0230-0148B
GENERAL OPERATION:
The Pi2 is a phase reversal switch that electronically reverses the phase of the pickup. You must have two pickups on the instrument in order
for the Pi2 to work. Reversing the phase of one of the pickups results in a tone that is typically very thin sounding and dependent upon the type of
pickups, the distance between them, and their frequency reponse. The Pi2 is installed on either pickup of a two pickup instrument.
On a three pickup guitar it is best installed on the middle pickup allowing phasing with both of the other pickups. The Pi2 does not
provide the “phased ” sound of Stratocaster* style guitars. That sound is derived from the simple mixing of two pickups in different places on
the instrument. The sound of the Pi2 is very unique. Because the Pi2 is used when mixing two pickups is has 2.5db of gain.
.600
1.250
.383
SHOWN IN
“ON” POSITION
6mm x 8mm H
RED (9V+)
OUTPUT
GROUND
INPUT
GROUND
* Stratocaster is a registered Trademark of FMIC.
INCLUDED:
1 Pi2 Control
1 Battery Clip with Buss Connector
1 Stereo Output Jack (Battery Switching)
2 Interconnect cables
INPUT
OUTPUT
S1
S1
EMG-Pi2
+