Emerson White Rodgers TTW1000, Руководство пользователя

Страница: 4 / 16

4
WALL SURFACE
6 IN.
AIR CLEANER
RETURN-AIR
DUCT
STUD
WALL SURFACE
RETURN-AIR
DUCT
AIR
CLEANER
6 IN.
STUD
SUPPLY-AIR
PLENUM
SUPPLY-AIR
DUCT
FURNACE
TYPICAL INSTALLATION USING DUCT EXTENSION
Figure 5
6 IN.
AIR CLEANER
STUD
SCREW HOLES
(TOP, BOTTOM AND
SIDES OF CABINET)
TAPE
RETURN-AIR
DUCT
TAPE JOINT
WALL
(OR CEILING)
SURFACE
CONNECTING
DUCT
TYPICAL INSTALLATION USING DUCT EXTENSION
Figure 6
RETURN-AIR DUCT
JOIST
CEILING SURFACE
6 IN.
AIR CLEANER
4 IN. MINIMUM
TYPICAL CEILING LOCATION
Figure 7
TYPICAL WALL LOCATION
Figure 4
PREINSTALLATION PREINSTALLATION PREINSTALLATION PREINSTALLATION PREINSTALLATION
LOCATING THE AIR CLEANER LOCATING THE AIR CLEANER
LOCATING THE AIR CLEANER LOCATING THE AIR CLEANER LOCATING THE AIR CLEANER
Your Thru-The-Wall Electronic Air Cleaner is mounted
at the return-air duct inlet. (See figures 4 through 7.) It
works equally well in either high or low wall installa-
tions, or in the ceiling. It can be used with any type of
forced-air heating or cooling system.
In most cases, return-air ducts are located just inside
the wall (or ceiling) grille. When the air cleaner is flush
mounted, it will extend through the wall cutout and into
the return-air duct. If the return-air duct is located at a
distance from the wall (or ceiling), extend a connecting
duct to the rear of air cleaner frame with sheet metal
screws.
NOTE NOTE NOTE NOTE NOTE: Always tape all ductwork joints with duct tape
to prevent dirt-laden air from entering ducts.
After deciding upon the exact location, make sure of
the following before cutting out wall or ceiling area:
1. Exact location of return-air duct behind wall (or
ceiling).
2. Location is free of obstructions, such as steel
support beams, piping or electric wiring.
3. Access to inner area for wiring connections.
4. Return-air duct is deep enough to accommodate air
cleaner (6 inches, see figures 4 through 8.)
5. Enough room is left at a corner or wall offset to
permit installation of the grille. (See figure 8.)