background image

7

6

8

NEW THERMOSTAT  OPERATION

This thermostat is easy to operate. After power is turned on, use the system switch to 
select heating, or to turn the heating system off.

SPECIFICATIONS

ELECTRICAL DATA
Switch Rating

......................................

 

24 VAC (30 VAC max.)

Heating.................................................. 

 

0.15 to 1.2 Amps

Anticipator Rating:

Heating..................................................  Adjustable from 0.15 to 1.2 Amps

THERMAL DATA:
Temperature Range

.............................  50°F to 90°F (10°C to 32°C)

Operating Humidity Range

.................  0 – 90% noncondensing

TROUBLESHOOTING

W

R

Heat

Anticipator

(adjustable)

Heating

System

24 VAC

120 VAC

Hot

Neutral

THERMOSTAT

SYSTEM

Figure 3. Typical wiring for single transformer heating system

Содержание White Rodgers 1E30N-910

Страница 1: ...er to the system at the main fuse or circuit breaker until installation is complete CAUTION Before removing wires from old thermostat s switching subbase label each wire with the terminal designation it was removed from 1 Remove Old Thermostat A standard thermostat consists of three basic parts a The cover which may be either a snap on or hinge type b The base which is removed by loosening all cap...

Страница 2: ...rmostat Base Gently push excess wire back into the wall opening and plug hole with a fire resistant material such as fiberglass insulation to pre vent drafts from affecting thermostat operation Mount the thermostat base to the subbase or wallplate using the three captive screws on the thermostat base See Fig 1 Tighten the screws securely Proceed to Step 5 TERMINAL CROSS REFERENCE CHART New Thermos...

Страница 3: ...DATA Switch Rating 24 VAC 30 VAC max Heating 0 15 to 1 2 Amps Anticipator Rating Heating Adjustable from 0 15 to 1 2 Amps THERMAL DATA Temperature Range 50 F to 90 F 10 C to 32 C Operating Humidity Range 0 90 noncondensing TROUBLESHOOTING W R Heat Anticipator adjustable Heating System 24 VAC 120 VAC Hot Neutral THERMOSTAT SYSTEM Figure 3 Typical wiring for single transformer heating system ...

Страница 4: ...connection to the thermostat to verify it is neatly looped under the terminals Constantly 2 Possible short in thermostat No extra wire should stick out from under the terminals 3 Possible short in heat cool fan system Furnace Cycles Too Fast See Step 5 Adjusting the Anticipator The anticipation setting is the only adjustment that effects the heating cycle rate If an accept or Too Slow Narrow or ab...

Отзывы: