4
Setting Operating
Frequency of SR600
Remote Control
1.
Slide the five switch levers in the
remote control to your choice of ON
(up) or down positions. Use a ball-point
pen or small screwdriver and slide the
levers firmly up or down.
2.
When power is restored, push and hold
the fan OFF button ( ) for 3 to 5
seconds to set the code in the receiver.
3.
If airflow is desired in the opposite
direction, press the ( ) button on the
wall control. The fan must be operating
at any speed for the reverse button to
function. The blades will turn in the
opposite direction and reverse the
airflow.
4.
To set the desired fan speed, press the
( ) button to decrease the speed and
the ( ) to increase the speed. The
LED display will light up to indicate the
new speed selected.
5.
To turn the downlight on, press and
release the ( ) button. The light will
turn on at the light intensity previously
selected.
6.
To turn the uplight on, press and
release the ( ) button. The light will
turn on at the light intensity previously
selected.
7.
To vary the intensity of the light, hold
the DN or UP button down until the
desired light intensity is reached, then
release the button.
8.
The sixth switch marked ON and I is for
dimming control of lights: Set switch to
ON to allow for dimming of the lights.
Set switch to I for no dimming of the
lights such as for fluorescent bulbs.
CODE
SWITCHES
SR600 REMOTE
CONTROL
BATTERY
COMPARTMENT
COVER
TWO AAA
BATTERIES
REMOTE CONTROL
LEVERS
ON
1
2
3
4 5
I
Figure 1
Your remote control has code switches
which must be set in one of 32 possible
code combinations. The five levers
(numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up)
position. Change the switch settings as
follows:
TO INSTALL BRACKET TO WALL:
SLIDE THE COVER UP TO EXPOSE THE SCREW
HOLES FOR INSTALLATION
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 2
Installation of Storage
Bracket for SR600
Remote Control
A storage bracket is provided for holding
your remote control when not in use. If you
desire to use the bracket, install it on a
wall that is away from excess heat or
humidity (Figure 2).
Installation of Battery
1.
Remove the battery cover by pressing
firmly below the arrow and sliding the
cover off the control (Figure 1).
2.
Install two AAA alkaline batteries and
reinstall the battery cover.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Page 4
