Emerson RSTi-EP CPE200 Series, Быстрый старт

Страница: 33 / 38

30
RSTi-EP CPE200 Series Controllers Quick Start Guide GFK-3109B
Reset to Factory Defaults
IMPORTANT
1. Before beginning, ensure the following:
2. The controller is in STOP disabled mode.
3. No USB stick is inserted.
4. The Password Web Page is not waiting for input
(password change).
1.
Begin by pressing the Physical Presence button (PHY
PRES) for 10 seconds, The OK LED and RUN LEDs will
blink
GREEN , indicating the Reset to Factory is occurring.
2.
Release the PHY PRES button.
3. Blinking will cease and the board will be reset.
4. The following actions will result.
a. Resets the IP addresses to their factory defaults
shown in section Ethernet Ports
b. Resets the Web page firmware password to its
default setting. (Password is
sierra
)
c. Deletes controller and IO faults
d. Clears NVRAM