![background image](http://html.mh-extra.com/html/emerson/mvme51005e/mvme51005e_installation-and-use-manual_103871041.webp)
3 PPCBug Firmware
MVME51005E Single Board Computer Installation and Use (6806800A38B)
23
Network PReP-Boot Mode Enable [Y/N] = N?
Negate VMEbus SYSFAIL* Always [Y/N] = N?
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Primary SCSI Bus Negotiations Type [A/S/N] = A?
Primary SCSI Data Bus Width [W/N] = N?
Secondary SCSI identifier = 07?
Select the identifier. (Default = 07.)
NVRAM Bootlist (GEV.fw-boot-path) Boot Enable [Y/N] = N?
Note
When enabled, the GEV boot takes priority over all other boots, including Autoboot and
Network Boot.
Y
Enable PReP-style network booting (same boot
image from a network interface as from a mass
storage device).
N
Do not enable PReP-style network booting.
(Default)
Y
Negate the VMEbus SYSFAIL
∗
signal during
board initialization.
N
Negate the VMEbus SYSFAIL
∗
signal after
successful completion or entrance into the bug
command monitor. (Default)
Y
Local SCSI bus is reset on debugger setup.
N
Local SCSI bus is not reset on debugger setup.
(Default)
A
Asynchronous SCSI bus negotiation. (Default)
S
Synchronous SCSI bus negotiation.
N
None.
W
Wide SCSI (16-bit bus).
N
Narrow SCSI (8-bit bus). (Default)
Y
Give boot priority to devices defined in the
fw-
boot-path
global environment variable (GEV).
N
Do not give boot priority to devices listed in the
fw-boot-path
GEV. (Default)