Chapter 2 Mechanical Installation 3
Liebert.CRV+ Condenser User Manual
Chapter 2 Mechanical Installation
This chapter introduces the moving, unpacking, inspection, installation notes, space requirements and installation
procedures.
2.1 Moving, Unpacking And Inspection
Moving
It is recommended to use mechanical transport equipment such as forklift or crane when unloading and transferring
the condenser closest to the installation site.
When a forklift is used, insert the tines of the forklift as shown in Figure 2-1.
For
klift
dire
ction
Figure 2-1 Forklift direction
Unpacking
Remove the paper package and foam of the condenser but reserve the protection cardboard of fins. The protection
cardboard of fins should be removed after the condenser is in its installation position.
Note
When moving the condenser by hand, to avoid distortion and system leakage, do not touch the copper pipes.
Inspection
After receiving the product, you should check the accessories against the packing list. If any parts are found missing or
damaged, please report to the carrier immediately. If any covert damage is found, please report to the carrier and the
local office of the product supplier.
2.2 Installation Notes
1. The outdoor unit should be installed in the place that is convenient for maintenance. Do not install the outdoor unit at
the bottom layer of the public place and the unit should be installed far away from the residential area.
2. Do not directly install the outdoor unit in the environment with high requirements for noise.
3. To ensure the heat dissipation capacity, install the condenser in a clean place that is far away from dusts and alien
objects to avoid obstruct the heat exchanger.
4. Do not place the unit close to vapors, hot gases and waste gases.
5 Keep at least 450mm clearance between the outdoor unit and the wall, barrier or neighboring equipment.
6. Do not place the unit at the air inlet side and air discharge side where snow may be accumulated.
