1. TUNE/SCAN Up Button
2. MEMORY Button
3. Battery Compartment (Rear)
4. Earbud Jack
5. Belt Clip
6. Rotary VOLUME/POWER
Control
1
2
1. Use only the size and type of batteries
speci
fi
ed.
2. Be sure to follow the correct polarity,
reversed batteries may cause damage
to the device.
3. If the device is not to be used for a
long period of time, remove the
batteries to prevent damage or injury
from possible battery leakage.
4. Do not mix different types of batteries
together (e.g. Alkaline and Carbon-
zinc) or old batteries with new ones.
LOCATION OF CONTROLS
POWER SOURCE
POWER SOURCE (CONTINUED)
OPERATION
4
3
5
6
Plug the earbuds into
the Earphone jack, then
insert the earbuds into
your ears. Rotate the
VOLUME/POWER con-
trol to turn the power
on.
1
Rotate the VOLUME/
POWER control to
adjust the volume.
Rotate the VOLUME/
POWER control to the
OFF position to turn the
unit off.
3
Press either TUNE/SCAN
button repeatedly to tune
in a station. To scan the
stations, press and hold
TUNE/SCAN Up button
until a 'beep' sound is
heard. The tuner will scan
up the FM band until it
finds a strong station and
then stop. Repeat until
the tuner stops on your
desired FM station.
2
FM ANTENNA:
The FM antenna is built into the earbud cord, extend for best reception.
LISTENING TO THE FM RADIO
Remove the belt clip by
pulling it out of the slots
while pressing both
sides of the belt clip.
1
Replace the two old
button batteries with new
ones (LR44 or G13). If
the batteries are inserted
incorrectly, the unit will not
operate. Close the battery
compartment cover firmly
and reinstall the belt clip.
+
3
Open the battery
compartment cover by
pushing the tab of the
cover using a small
screwdriver tip.
2
BATTERY REPLACEMENT
BATTERY OPERATION
1. The batteries are pre-installed in the battery
compartment at the factory. To activate the batteries,
pull the battery spacer out as shown.
BATTERY PRECAUTIONS
Up to four memory
presets can be stored.
Press the TUNE/SCAN
Up button to select a
desired station.
1
To listen to a memory
preset, press the Memory
button repeatedly until
the desired memory
preset is selected.
3
Press and hold the
Memory button until a
beep is heard and the
station will be memor-
ized. To store the next
preset, press the
Memory button again
and repeat steps 1 and
2 (up to four presets).
2
MEMORY PRESETS
OPERATION (CONTINUED)
To preserve the battery life, be sure to rotate the VOLUME/POWER control to
the OFF position.
CLEANING:
If your mini radio becomes dirty, wipe it with a soft cloth. Do not
use thinner, benzine or similar chemicals as this will damage the unit.
All manuals and user guides at all-guides.com
