Emerson Fisher FIELDVUE DVC6000f, Инструкция по эксплуатации, Страница: 362 / 384

DVC6000f Digital Valve Controllers
December 2009 F-12
Figure F-4. Accessing Configure/Setup, Device Diagnostics, and Device Variables
DEVICE
DIAGNOSTICS
DEVICE
VARIABLES
DIGITAL VALVE
CONTROLLER
(TRANSDUCER)
RESOURCE
(RESOURCE)
Resource Block
For detailed information on the parameters that are
changed via the resource block, refer to the Detailed
Setup section of this manual. Refer to figures F-2, F-3,
and F-4 for information on accessing resource block
parameters.
1. Start DeltaV Explorer by selecting DeltaV Explorer
from the Start menu.
2. Locate the digital valve controller icon in the All
Containers pane and right-click once on the block icon
or name.
3. Locate Open with AMS Device Manager in the
context menu and left-click to bring up the Device
Connection View.
4. Navigate to the digital valve controller icon or name
as shown in figure F-2 and left-click.
5. Locate Configure/Setup in the Actions menu (see
figure F-3) and left-click to access Configuration and
Setup parameters.
6. Left-click on Resource (RESOURCE) to access the
resource block parameters. Refer to table F-2 for the
resource block configuration menu.
Note
To access diagnostic parameters
left-click on Device Diagnostics, and
then on Resource (RESOURCE). See
figure F-4.
To access device variables left-click on
Device Variables, and then on
Resource (RESOURCE). See figure F-4.
Bringing the Device On-Line
To completely configure the digital valve controller for
use in a fieldbus loop, the following conditions must be
met. Refer to DeltaV On-Line-Help or documentation
for detailed information on accomplishing these steps.
1. A place holder must be created
−
a place holder is
an electronic representation of the digital valve
controller that exists in the DeltaV database with no
associated physical device.
2. Device must be commissioned
−
Commissioning
the device involves downloading applicable
parameters from the device place holder to the
physical device.
F