6
Base layout
2
3
1
4
5
6
7
1. Charging / in use (flashing)
2. Display for answering machine
3. Power
4. Key for answering machine:
5. Paging key
6. Microphone
7. Charging contacts for handset
Key
In idle mode
During playback
briefly: check number of rings
decrease speaker volume
press and hold: set number of rings
briefly: turn answering machine on/of stop playback
press and hold: select OGM
briefly: play OGM
back to previous message
press and hold: record OGM
(during settings: decrease value)
briefly: check remote PIN
increase speaker volume
press and hold: set remote PIN
briefly: confirmation “Delete all“
Delete current message
press and hold: delete all messages
briefly: (no function)
skip to next message
press and hold: record memo
(during settings: increase value)
briefly: playback messages
Pause
17
Troubleshooting
Telephone
No dial tone
● Check or repeat installation steps:
- Make sure the base power is connected to a working electrical outlet.
- Make sure the telephone line cord is connected to the base and the wall
jack.
● Connect another phone to the same jack. If it doesn’t work, the problem
might be your wiring or local service.
● The handset may be out of range of the base. Move closer to the base.
● Make sure the battery is properly charged (for 16 hours).
● Make sure the battery in the handset is properly installed.
● The handset should beep when you press the TALK button, and the charge
indicator on the base should lit when the handset rests in the cradle, If
not, the battery may need to be charged.
● Place handset in charge cradle for at least 20 seconds to reset the unit.
Handset does not ring
● Make sure the ringer switch is set to the
ON
position.
● The handset may be out of range of the base. Move closer to the base.
● Check for a dial tone.
You experience static, noise, or fading in and out
● The handset may be out of range of the base. Move closer to the base.
● Make sure the base is not plugged into an electrical outlet with another
household appliance. If necessary, relocate the base.
● Charge the battery for 16 hours.
Storing telephone numbers
When the desired telephone number is displayed, press the button. Select
SAVE
TO PB
if necessary and press the button. Enter the name and press the
button. Edit the telephone number if necessary. Press the button for deleting the
last character or press and
HOLD
for deleting the whole number. You can enter a dialing
pause (approximately 3 seconds) by pressing the button.
Press the button again to select a melody for the entry.
Press the button to store the entry.
Deleting telephone numbers
When the desired telephone number is displayed, press the button.
Select DELETE or DELETE ALL if necessary and press the button. The entry or all
entries will be deleted.
MUTE
OK
MENU
OK
MENU
OK
MENU
OK
MENU
OK
MENU
OK
MENU
OK
MENU
PAUSE
