7
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF790
3. Ceiling Fan Assembly
(Continued)
4.5"
DOWNROD
CEILING
COVER
Figure 6
3.7
Place the ceiling cover over the downrod. Be sure both
the ceiling cover and the coupling cover are oriented
correctly (Figure 6).
4.5" DOWNROD
HANGER BALL
PIN
SETSCREW
Figure 7
3.8
NOTE: Only use the hanger ball supplied with this
ceiling fan.
Route the three 80” motor leads through the hanger
ball.
Reinstall the hanger ball (Figure 7) on the downrod as
follows:
Position the hanger ball pin through the two holes in the
downrod and align the ball so the pin is captured in the
groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball.
NOTE: A loose setscrew could create fan wobble.
HANGER BALL/
DOWNROD
ASSEMBLY
6 to 9
INCHES
Figure 8
3.9
The fan comes with black, blue and white leads that are
80-inches long.
Before installing the fan, measure up approximately
6 to 9-inches above top of hanger ball/downrod
assembly (Figure 8).
Cut off excess leads and strip back insulation 1/2-inch
from end of leads.
