1.
Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 1). Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in step 5.
2.
Separate, untwist and unkink the three 80” motor
leads. Route the motor lead wires through the
downrod.
3.
Remove the setscrew (Figure 2) from the motor
coupling. Align the clevis pin holes in the downrod
with the holes in the motor coupling. Install the cle-
vis pin and secure with the hairpin clip (Figure 2).
The clevis pin must go through the holes in the
motor coupling and the holes in the downrod. Be
sure to push the straight leg of the hairpin clip
through the hole near the end of the clevis pin until
the curved portion of the hairpin clip snaps around
the clevis pin. The hairpin clip must be properly
installed to prevent the clevis pin from working
loose. Pull on the downrod to make sure the clevis
pin is properly installed.
4.
Reinstall the setscrew in the motor coupling. While
pulling up on the hanger ball, securely tighten the
setscrew.
NOTE: The setscrew must be properly installed as
described above, or fan wobble could result.
5.
Make sure the grommet is properly installed in the
coupling cover, then slide the coupling cover on the
downrod until it rests on the motor housing. Place
the ceiling cover over the downrod. Be sure that
the ceiling cover and the coupling cover are both
oriented correctly (Figure 3).
6.
Reinstall the hanger ball (Figure 4) on the downrod
as follows. Route the three 80” motor leads through
the hanger ball. Position the pin through the two
holes in the downrod and align the hanger ball so
the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against the
pin and securely tighten the setscrew in the hanger
ball. A loose setscrew could create fan wobble.
7.
The fan comes with blue, black and white leads
that are 80-inches long. Before installing the fan,
measure up approximately 6 to 9-inches above top
of hanger ball/downrod assembly. Cut off excess
leads and strip back insulation 1/2-inch from end of
leads.
8.
Mount blade flanges to fan blades using three
M5 x 6 washer head screws and three blade
washers (Figure 5).
4
How to Put Your Ceiling Fan Together
HANGER BALL
DOWNROD
CLEVIS PIN
SETSCREW
Figure 1
SETSCREW
PIN
CEILING COVER
DOWNROD
HANGER
BALL
Figure 4
CEILING
COVER
GROMMET
DOWNROD
COUPLING COVER
Figure 3
DOWNROD
MOTOR
COUPLING
HAIRPIN
CLIP
SETSCREW
CLEVIS PIN
HAIRPIN
CLIP
CLEVIS
PIN
SETSCREW
MOTOR COUPLING
Figure 2
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are proper-
ly installed could result in the fan falling.
WARNING
!
U.L. Model No.: CF935
