10
ETL Model No.: CF921
Figure 14
Your remote control has code switches which must be
set in one of 32 possible code combinations. The five
levers (numbered 1, 2, 3, 4, and 5) on the switches are
factory-set in the ON (up) positron. Change the switch
settings as follows (Figure 14).
1.
Slide the five switch levers in the remote control to
your choice of ON (up) or down positions. Use a ball-
point pen or small screwdriver and slide the levers
firmly up and down.
2.
The sixth switch marked ON and I is for dimming
controls of lights (if accessory light is installed).
Set switch to ON to allow for dimming of lights.
Set switch I for no dimming of lights such as
fluorescent bulbs and non-dimming CFLs.
Your SR600 Fan/Light remote control (Figure 14) has
full control of your fan speed, air flow direction and light
intensity.
1.
If airflow is desired in the opposite direction, press
the ( ) button on the wall control. The fan must be
operating at any speed for the reverse button to
function. The blades will turn in the opposite direction
and reverse the airflow.
2.
To set the desired fan speed, press the ( ) button to
decrease the speed and the ( ) to increase the
speed. The LED display will light up to indicate the
new speed selected.
3.
To turn the downlight on, press and release the
( ) button. The light will turn on at the light intensity
previously selected.
4.
To turn the uplight on, press and release the ( )
button. The light will turn on at the light intensity
previously selected.
5.
To vary the intensity of the light, hold the DN or UP
button down until the desired light intensity is
reached, then release the button.
6.
The sixth switch marked ON and I is for dimming
control of lights:
Set switch to ON to allow for
dimming of the lights. Set switch to I for no dimming
of the lights such as for fluorescent bulbs.
6. Remote Control Procedures
(continued)
Fan installation must be completed, including the
installation of the fan blades, before testing the
remote control.
WARNING
!
Installation of Storage Bracket for
SR600 Remote Control
A storage bracket is provided for holding your remote
control when not in use. If you desire to use the
bracket, install it on a wall that is away from excess
heat or humidity (Figure 15)
TO INSTALL BRACKET TO WALL:
SLIDE THE COVER UP TO EXPOSE THE
SCREW HOLES FOR INSTALLATION
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 15
