3. Once wiring is completed, lift the motor bracket so
that the four threaded studs on the mounting plate
protrude through the four slot in the motor bracket.
(See Figure 4.)
Securely tighten the four 1/4” locknuts (supplied)
onto the threaded studs, then try to shake the
motor bracket to ensure that the assembly is tight.
Proceed to section "HOW TO PUT YOUR CEILING
FAN TOGETHER".
OUTLET BOX
MOUNTING
PLATE
SWITCH
HOUSING
FAN MOTOR
1/4" LOCKNUTS
(SUPPLIED) (4)
MOTOR
BRACKET
Figure 4
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
1. Connect the green grounding wires from the motor
bracket and the mounting plate to the grounding
conductor of supply (this may be a bare wire or wire
with green colored insulation).
NOTE: If you are using an Emerson Light Fixture
with your fan, see the Light Fixture Owner’s
Manual for wiring.
2. Connect the fan motor white wire to the supply
white (neutral) wire using a listed wire connector
(Figure 5).
3. Connect the fan motor black wire and blue wire to
the supply black (hot) wire using a listed wire
connector (Figure 5). Your fan is now wired to be
turned on and off from the fan switch. After
connections have been made, turn leads upward
and carefully push leads into the outlet box, with
the white and green leads on one side of the outlet
box and the black and blue leads on the other side
of the outlet box.
4. Connect the wood ball with chain to the 3-speed
switch pull chain.
5. Return to step 3 of section" HOW TO HANG YOUR
CEILING FAN".
How To Wire Your Ceiling Fan
MOUNTING
PLATE
MOTOR BRACKET
BLACK
SUPPLY
(HOT)
WHITE SUPPLY
GREEN GROUND WIRE
BLUE FAN WIRE
WIRE
CONNECTORS
SUPPLY GROUNDING WIRE
WHITE FAN WIRE
GREEN GROUND WIRE
BLACK FAN WIRE
Figure 5
5
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice,
as it must be grounded for safe operation.
WARNING
!
To avoid risk of fire or shock, check to see that all
connections are tight, including ground, and that no
bare wire is visible at the wire connectors, except for
the ground wire. Do not operate fan until blades are
in place. Noise and fan damage could result.
WARNING
!
