August 2022
Installation, Operation and Maintenance Manual
VCIOM-17114-EN Rev. 1
10
Installation
Section 2: Installation
•
Remove the 3-wire power connector cable from the power card as shown in Figure 17.
•
Remove the 2-pins connector cable from J1A on the logic card as shown in Figure 18.
Figure 17
Figure 18
•
Connect the 3-wire power connector cable from the terminal board to the OM13
as shown in Figure 19.
•
Place the OM13 card onto the heatsink spacers (if necessary use 3.2 mm height
plastic spacers) and tighten the 4 screws as shown in Figure 20.
