8.
Place the upper housing plate so that the two
notched areas align with the two studs on the motor
coupler. Aligning the six screw holes of the upper
housing plate onto the motor hub. Firmly attach the
upper housing to the motor hub/upper housing plate
by using the six #8-32 x 1/2” pan head screws with
lockwashers (supplied) (Figure 4).
9.
Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 5). Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in Step 12.
10.
Separate, untwist and unkink the three 80” motor
leads. Route the motor lead wires through the
downrod. Align the clevis pin holes in the downrod
with the holes in the motor coupler. Install the clevis
pin and secure with the hairpin clip (Figure 6). The
clevis pin must go through the holes in the motor
coupler and the holes in the downrod. Be sure to
push the straight leg of the hairpin clip through the
hole near the end of the clevis pin until the curved
portion of the hairpin clip snaps around the clevis
pin. The hairpin clip must be properly installed to
prevent the clevis pin from working loose. Pull on
the downrod to make sure the clevis pin is properly
installed.
11.
While pulling up on the downrod, reinstall and
tighten the two setscrews (previously removed in
Step 6) in the motor coupler (Figure 6).
12.
Make sure the grommet is properly installed in the
coupler cover, then slide the coupler cover on the
downrod until it rests on the motor housing. Place
the ceiling cover over the downrod. Be sure that the
ceiling cover and the coupler cover are both
oriented correctly (Figure 7).
13.
Reinstall the hanger ball (Figure 7) on the downrod
as follows. Route the three 80” motor leads through
the hanger ball. Position the pin through the two
holes in the downrod and align the hanger ball so
the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against the
pin and securely tighten the setscrew in the hanger
ball. A loose setscrew could create fan wobble.
6
ETL Model No.: CF766
COUPLER COVER
CEILING
COVER
PIN
HANGER
BALL
GROMMET
EU
P
T H I S S I D E U P
T H I S S I D E U P
DOWNROD
Figure 7
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!
HAIRPIN CLIP
MOTOR COUPLER
DOWNROD
CLEVIS
PIN
HAIRPIN
CLIP
MOTOR
COUPLER
SETSCREW
CLEVIS PIN
UP
T H I S S I D E U P
T H I S S I D E U P
REINSTALL
SETSCREW (2)
Figure 6
T H I S S I D E U P
#8-32 x 1/2" PAN
HEAD SCREW WITH
LOCKWASHER (6)
REINSTALL
SETSCREW (2)
MOTOR COUPLER
MOTOR
COUPLER
STUD (2)
UPPER HOUSING
PLATE
Figure 4
DOWNROD
PIN
SETSCREW
HANGER BALL
Figure 5
It is critical that the clevis pin in the motor coupler is
properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed (as shown in Figure 6) could
result in the fan falling.
WARNING
!
3. Ceiling Fan Assembly
(continued)
