emerio WD-118981, Инструкция по эксплуатации

Страница: 6 / 28

- 5 -
WD-118981 EN
PARTS DESCRIPTION
1.
Temperature control knob
2. ON/off button
3. Indicator light
4. Spout
5. Tray
6. Tray cover
7. Tank cover
8. Water tank
9. Housing
10. Reset key
11. Drainage stopper
BEFORE USE
If you are using the appliance for the first time, please clean the water tank before use. Always unplug from the
plug socket before cleaning.
Fill the water tank with clean water, plug in and press the On/off switch to turn on the appliance, let the water
flow out until the tank is empty and repeat the same steps for several times, then refill with clean water to be
ready for operation.
CAUTION! Before use ensure the drainage stopper under appliance is well tightened.
USE
1.
Open the lid, fill the water tank with the desired amount of water, and then close the lid. Note: do not fill
over the Max level. The water tank can be disassembled to clean or fill.
Tips: We suggest to use purged water.
2. Place your cup on the removable tray, make sure it aligns with the spout.
3. Plug in the appliance.
4. Turn the temperature control knob to select the desired temperature.
5. Press the On/off switch (to a higher position) to turn on the appliance, the indicator light will first
illuminate red, and then illuminate green.
The red light here indicates that the inner water pump is pumping water to the inner storage box. It will
turn into green in a second. If the water tank is empty, the indicator light will also illuminate red.
6. The desired water will flow out continuously from water spout in about 5-10 seconds.
7. Press the ON/off switch again, the appliance will be turned off. The indicator light will be off. If you want
to obtain water again, repeat above procedure.
Note:
(1) To protect against scalding, do not touch the boiled water and steam.
(2) When the water tray is full, remove the water tray and empty it; insert it back properly.
RESET THERMOSTAT
The appliance has a reset thermostat to recover the heating function after
abnormal operation; if the unit doesn’t switch on, stop working, is not boiling
water, you can reset the thermostat by a reset key easily. (A: reset hole; B: reset
key)
CLEANING AND MAINTENANCES
1.
Always switch off and unplug the appliance and allow it to cool completely
before cleaning.
2. Do not immerse the appliance into any liquid to avoid the damage.