- 7 -
1.
Put the appliance on a stable flat surface.
2.
Fill the water from the top water supply port slowly. Note that if the water level gauge reaches the top
Max line, stop adding water, otherwise the water will overflow from the main unit.
3.
Plug the power cord to the port on the main unit, and then connect the power plug to the appropriate
power supply.
4.
After the appliance is powered on, all indicator lights light up for about 2 seconds, and then turn off. The
appliance enters the standby state. The switch indicator light turns red, and other indicator lights are off.
5.
Press the switch once, the appliance runs in AUTO mode and the appliance displays the current relative
humidity. The switch indicator light turns green.
6.
Press the humidity adjustment buttons to set the desired relative humidity in a range from 20% to 65%.
(The default is 50%. Each press of the humidity adjustment button leads to a change of 1%.) After setting,
the display turns back to the current relative humidity.
7.
When the appliance is in AUTO mode, press the switch button once, the appliance will run in low speed
mode (the fan works in low speed), and if you press the switch button once more, the appliance will run in
high speed mode (the fan works in high speed).
8.
When the appliance is in high speed mode, press the switch button once, the appliance will get back to
Auto mode. The three modes are switched in a cycle. However, only in the Auto mode, the desired relative
humidity can be adjusted.
9.
Night mode:
Press the two humidity adjustment buttons (
“ ”
+
“
”
) at the same time for about 1 second, the
night mode is activated. All lights turn off but the appliance keeps running.
When the night mode is on, press any button to cancel the night mode, and indicator lights turn back
on.
10.
To stop the appliance manually, long press the switch button for about 2 seconds. The appliance enters
standby mode and the switch indicator light turns red.
NOTES
This is not an aroma humidifier. Do not put essential oils or chemicals in the water.
When there is not enough water in the water tank, the appliance will automatically stop working and the
switch indicator light will turn red. Add more water if you need to use the appliance.
If the water tank is taken out when the appliance is working, the appliance will stop working immediately
and the switch indicator light will flash in red.
CLEANING AND MAINTENANCE
1.
Take out the plug from the power outlet.
2.
Remove the cover and use a sponge or soft cloth to wash the cover with tap water.
