emerio FH-121976, Инструкция по эксплуатации

Страница: 7 / 39

- 6 -
3. Power setting button
Under working condition, you can press button “ ” to switch the power setting between low heating power
and high heating power.
- Low heating power: Icon “ ” will be shown on the digital display.
- High heating power: Icon “ ” will be shown on the digital display.
The heater works on low heating power when the room temperature is 0-2
℃
lower than the set temperature.
The heater works on high heating power when the room temperature is 4-5
℃
lower than the set temperature.
4.
Oscillation button
Under working condition, you can press button “ ” to activate or deactivate the swing function. The digital
display will show icon “ ” lighted on when swing function is activated.
5.
Timer button
Under working condition, you can press button “ ” to set timer.
Press the button “ ” once, the appliance enters the timer setting mode. You can press “ ” to adjust the
timer from 0 – 8H (each press changes the value of one hour and “0H” means no timer). The corresponding timer
value will be shown on the digital display. The set timer will be activated in 5 seconds without any other operation
and then the digital display will show back the room temperature. The icon “ ” on the display indicates the
timer has been set. When the timer is counting down to 0 (not shown on the display), the appliance will stop
working automatically (a beep sound will be sent out) and enter standby mode.
Note:

If no operation for 10 minutes, the digital display and indicator light will go out. Press once any one of the
buttons can make the display and indicator light come back.

The heater will remain hot for some time after it is turned off; handle it with care.
REMOTE CONTROL
This unit has a remote control. One piece of CR2025 battery should be used for it. The functions of the remote
control buttons are the same as of the buttons on the control panel. Follow the illustration on the back of the
remote control to place or remove battery. Pay attention to the battery polarity when placing the battery.
SAFETY SYSTEM

The appliance has a safety system which automatically switches off the unit when overheated.

If overheating occurs, switch off the appliance, remove the plug from the socket, and let it cool down for at
least 30 minutes. Put the plug in the socket and switch on the heater.

This heater is equipped with a tilt protection safety device. For safety reasons, the unit will automatically
switch off the power if it is put on unstable or uneven surfaces or if it is tilted accidentally.