Emergi-Lite
Tel: (888) 552-6467
Fax: (800) 316-4515
www.emergi-lite.com
07/14 750.1789 Rev. A
ELX LED Exit Series
1/2
ELX LED Exit Series
AC and Self-Powered models
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always
be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. All servicing should be performed by qualified service personnel.
2. Disconnect power at fuse or circuit breaker before installing or servicing.
3. All electrical connections must be in accordance with local codes, ordi-
nances and the National Electric code.
4. Do not use outdoors.
5. Do not let power supply cords touch hot surfaces.
6. Do not mount near gas or electric heaters.
7. Equipment should be mounted in locations and at heights where it will
not readily be subjected to tampering by unauthorized personnel.
8. The use of accessory equipment not recommended by the manufacturer
may cause an unsafe condition.
9. Do not use this equipment for other than intended use.
10. Allow battery to charge for 24 hours before first use.
SAVE THESE
INSTRUCTIONS
Installation Instructions
1. Turn off AC power.
2. Using a flat head screwdriver, insert the blade into the slots and gently
pry off the front cover (see figure 4).
3. Follow the proper mounting procedure below.
Wall Mount (see figure 1)
a. With the front cover open, remove the center and appropriate
knockouts in the back plate to mount to the junction box.
b. Route AC supply leads throught the center hole for the back plate.
c. Mount the unit securely to the junction box using the junction box
screws.
d. For electrical connections see section 4 below.
Ceiling or End mount
a. Attach crossbar to junction box, set the longer blade of the crossbar
to touch the junction box.
b. Remove the mounting hole cover from the top or side of the unit
depending on your mounting configuration (see figures 2 and 3)
c. Install canopy according to mounting configuration (see figures 2,3
and 5).
WARNING:
Risk of Shock.
Disconnect Power before Installation.
Figure 1
Figure 2
Figure 3
Figure 4
Parts List
1.
Housing
2.
EXIT panel
3.
Back plate
4.
Mounting hole cover
5.
Chevron
6.
Red or green diffuser
7.
Canpoy
8.
Canopy screws
9.
Wire nuts
10. Junction box (not sup-
plied)
11. Crossbar
12. Crossbar screws (not pro-
vided)
