- 13 -
The water in the heater is not suitable for drinking.
WARNING:
Forbid any interference with a sealed component,
a fire or explosion may result causing
property damage, personal injury or loss of life.
■
Handle with abnormal conditions
If there is abnormal burning (flame light-back, flame lift, yellow tip or black smoke, etc), smell or noise,
or other emergent situations, keep calm and shut off the gas supply valve and power switch, and contact
the service facility or gas dealers for repair or adjustment.
▲
Scald prevention
●
Do not look closely at the flame check window when igniting so as to avoid burning eyes. Keep 300mm
away.
When using the heater discontinuously, be careful not to be scalded by the over high temperature hot
water at the start and stop times.
During use and immediately after, do not touch any places especially the surround of the flame check
window or the front cover except for the knob and control panel in order to avoid scalding.
Maintenance
▲
Always check the gas pipe for cracks.
▲
Clean the filter in the water inlet faucet monthly.
▲
Always check for leaking water.
▲
Ask qualified technicians to examine the burner, flue and fan once a year.
▲
Always check the flame inside the water heater for any abnormal conditions.
▲
Keep the cover of the water heater clean.
▲
This product uses water pressure to open the channels. When the water pressure is lower than 0.2bar, the
heater cannot be ignited.
▲
The drain valve is dripping. When the water pressure is too high, the drain valve will release the water so
as to reduce the pressure to protect the heater.
▲
When the heater is supplying hot water to several points at the same time, the hot water flow would be
reduced, or no hot water will issue at all.
▲
When the temperature outside is too low and the exhausted gas meets the cold air, it will be condense as
white fog. This is normal.
▲
When the water temperature is too high, set to a lower temperature and reduce the water tap. If the water
temperature outlet is too high, please open the tap to reduce the temperature.
▲
When the water temperature is too low, and the hot water volume is so high so that it exceeds the
heater’s heating power, the outlet water will be not hot enough, please reduce the water volume.
▲
In order to ignite immediately, the fan in the appliance will delay running for a long time and then stop
automatically. This is normal.
▲
When you use the multi-function shower, the resistance may be too large, and the water inlet pressure
will be too low or the water inlet volume will be too little (below the starting –up water volume), there
may be flameout or can not be ignited, please choose the suitable shower function.