RP 100 6 Bedienungsanleitung eng
Seite 3 von 4
Make sure that the testing object is in a tensionless state and do not use the test
buzzer around wet environments. Additionally you have to make sure that the
measuring lines are in a flawless condition.
The test buzzer confirms continuity with an acoustic signal of 70 dB(a) at a distance
of 22 cm.
4
Maintenance
When the test buzzer is used according to the instruction manual no particular maintenance
is required. It is still possible that the test buzzer gets dirty from time to time. If this is the
case the battery box can be cleaned with a moist towel and a little bit of mild household
cleaner.
4.1
Battery change
After some time of use the battery needs to be changed. This will be recognized when the
test buzzer doesn’t work flawlessly anymore.
After you have disconnected the test buzzer from all the measuring circuits, proceed as
indicated below:
1. Open the battery box as showed on the picture below.
2. Remove the old battery and insert the new 9 V block battery (IEC 6 F 22) poled
correctly.
3. Close the battery box.
Dispose the old battery appropriately.
The battery should be removed if the test buzzer is not being used during a longer
period of time.
5
Technical data
Currant over test terminal
24 mA (1 k
Ω)
Voltage over test terminal
9 V
Resistance test range
0 - 1 k
Ω
Protected against external
voltage up to
36 V AC
Intermittent alarm by
alternating voltage
No
LED visual indication
No
Battery
9 V (IEC 6 F 22)
Length of test cable
1 m
Temperature range
-5°C to +50°C
Life expectancy
10 years
Sign of conformity, approves compliance of the valid EMC directive (2014/30/EU). The
device is in compliance with the following standards: EN ISO 12100, EN 60204-1, EN
61000-6-2, EN 61000-6-4, low voltage directive (2014/35/EU).
