DPSI Ampere Operating Instructions
Version 1.0
Page 5 of 28
2. Safety Instructions
In general, all connecting lines should be run so that they do not
come into contact with moving or hot parts of the model (such as
servos, gears or mufflers).
High current carrying cables of electrically drives must keep a
distance of at least 3cm (1.2") to the DPSI Ampere.
The
DPSI must be protected from humidity and moisture.
The
DPSI must be located at a sufficient distance from
neighboring surfaces to enable good heat dissipation of the
cooling element.
Improper handling of the DPSI can result in serious damage/injury
to property or persons!
Carry out a general inspection of all connections in your model
before each use! All plugs must be correctly polarized and have
clean contacts (i.e. fit tightly). Loose cables present a potential
hazard!
Under no circumstances may power sources that do not meet the
specified voltages be used.
The current-conducting contacts of the connector plugs may not
be short-circuited. If you fail to observe this warning, the short-
circuited cables may overheat and even melt.
The
DPSI may not be taken apart or technically altered under any
circumstances.
Never use the DPSI for purposes other than for RC model making
as a hobby. Above all, their use in passenger-carrying equipment
is strictly prohibited.
Operate
the
DPSI only with the remote control components
provided for model making.
Always ensure that you have fully charged batteries when
operating your model. Empty batteries inevitably lead to failure of
the RC components, which cause the model to crash.
