Emco-test DuraJet 10 G5, Инструкция по эксплуатации, Страница: 39 / 80

Hardness Tester Basic Operation
DuraJet 10
4-4
Test data management "Standard". All data items are archived in
a standard list.
Test data management "Grouped". The test data items are stored
in a user-defined list.
Creates a new test data group / opens the "New test data group"
menu
To load an existing test data group / opens a list of all existing
groups.
Single test method (for individual measuring points)
Jominy test method (for measuring sequences to Jominy
standard)
Loading a template: Opens a list of all created templates for
selection
Saving a template: Opens the "Save template"" menu. All
settings (including "Group" if test data management "Grouped"
was selected) are accepted.
Code scanning: Opens a request for input. If you read a code via
a connected bar code or QR code scanner that is linked with an
existing template, this code is loaded and you get to "Testing".
Icons for the individual test methods
Geometric correction of spheric surfaces
Geometric correction of cylindrical surfaces
Shows, if conversion is active, the test method and the converted
method
Shows warnings (for example: Conversion boxes or values below
and above the selected hardness line).
Start measurement: Starts a test when the workpiece is clamped.
With unclamped measurement, the indenter must be positioned
as closely as possible to the sample.
Next sample: (Only available with test data management
"Grouped") Opens an input request for the designation of the next
sample. All subsequent measuring points have this designation
assigned until the function is used again.
Closing a group: (Only available with test data management
"Grouped") Terminates the test sequence and opens a selection
of further actions (to the archive to view the results, or to the
sample step to start with another sample).
Opens controller and switch for the working position lighting
Continue group: Change to the workflow step "Test". All
measurements are appended to the list.
Editing test point information: To rename the "Test point
information" box in the list of measured values
Select: To select several lines in the list of measured values
Deletes the selected lines
Deletes the entire list
Buttons - sample
Buttons - methods
Buttons - testing
Buttons - archive