4
SVR-D2U-R710 Installation and Replacement Guide
Installing the server in a rack or cabinet
Installing the server in a rack or cabinet
This section describes how to install the SVR-D2U-R710
server. It is
divided into the following sections:
◆
“Mounting kit parts” on page 4
◆
“Removing inner rails from the universal rail kits” on page 5
◆
“Attaching the inner rails” on page 5
◆
“Installing the universal rails in the cabinet” on page 6
◆
“Installing the server in the cabinet” on page 7
◆
“Installing bezels” on page 10
Mounting kit parts
The server mounting kit includes rails, hardware, and bezel as listed
in the following table.
You will need a # 2 Phillips-head screwdriver to complete the
installation of the rails and server.
Component
Use
Two adjustable universal slide rails
Attach front to back on either side
between NEMA channels
Two Phillips M5 18 mm screws
Stabilize the rail mounting
2 U bezel (front rack panel)
One per server — application specific
(includes inner rails for
connection to server)
