Specifications
73
EMC® VNX5300™ Hardware Information Guide
Specifications
lists the Block and File VNX5300 platform physical specifications, operating
environment, and power requirements.
Table 46
VNX5300 platform specifications
Parameter
Characteristics
Dimensions (approximate)
Height
14 in. (35.56 cm) 8 NEMA units (U) total, disk processor enclosure (DPE,
3U, standby power supply (SPS) 1U, Control Station 1U, Data Mover
Enclosure 2U, including mounting rails (fully configured with two Control
Stations and one Data Mover Enclosure having two Data Movers)
Width
18.92 in. (48.06 cm); mounting bars fit standard 19-inch NEMA cabinets
Depth
Chassis to rear: 21.30 or 24.25 in. (54.10 or 61.60 cm), depending on disk
drive carrier size
Weight
206.7 lb (93.76 kg) to 229.7 lb (104.19 kg); one DPE, one SPS, two
Control Stations, and one Data Mover Enclosure, depending on the
amount and the size of the disk drive modules
Operating environment
Temperature
50-104° F (10-40° C)
Temperature gradient
18° F/hr (10° C/hr)
Relative humidity
20% to 80% (non-condensing)
Altitude
7,500 ft (2286 m) @ 104° F (40° C) max.
AC power and dissipation
AC line voltage
100 to 240 VAC (47-63 Hz), single phase
AC line voltage tolerance
Voltage ± 10%, frequency ± 3 Hz
AC line current
4.8 A max at 100 VAC, 2.4 A max at 200 VAC
a
4.7 A max at 100 VAC, 2.3 A max at 200 VAC
b
4.6 A max at 100 VAC, 2.3 A max at 200 VAC
c
Power consumption
480 VA (454 W) max
a
; 465 VA (440 W) max
b
, 460 VA (450 W) max
c
Startup surge current
22 A rms max for 50 ms, at any line voltage
Power factor
0.98 min at full load, low voltage
Heat dissipation
1.58 x 10
6
J/hr, (1,500 Btu/hr) max
c
; 1.62 x 10
6
J/hr, (1,540 Btu/hr) max
b
;
1.64 x 10
6
J/hr, (1,560 Btu/hr) max
a
;
In-rush current
15 A max for ½ line cycle, per line cord at 240 VAC
15 A max for ½ line cycle, per line cord at 120 VAC
AC protection
12.5 A fuse on each power supply, both phases
ac
7.8 A fuse on each power supply, both phases
b
