EMC Connectrix ED-64M, Руководство пользователя

Страница: 340 / 476

E
E-6
Connectrix ED-64M User Guide
Command Line Interface
Command Tree
The command tree of the CLI begins from the Root. The commands in
the four extended branches (config, maint, perf, and show)
supported on the ED-64M are described later in this appendix.
There are three additional commands (login, logout, and
commaDelim
) that are not true branches. These commands are
described later in this section.
Table E-2 shows the hierarchy under the Root (reading from left to
right). The commands (with the exception of the zoning commands)
are listed in alphabetical order to make them easier to locate.
Although the commands can be entered in any order (depending on the
desired results), the order shown in Table E-2 for the zoning commands is a
typical order in which the zoning commands are entered.
Note that the order in which commands are entered determines the
order in which the show commands display the values.
<ESC>[B Down Arrow Move down one line in the command history.
<ESC>[C Right Arrow Position the cursor right one character.
<ESC>[D Left Arrow Position the cursor left one character.
Table E-1
CLI Command Tree Navigation Conventions (continued)
Character Sequence Common Name Action or Description
Table E-2
CLI Command Tree
config -------------------- enterpriseFabMode setState
features ----------------- installKey
enterpriseFabMode
ficonMS
openSysMS
show
ficonMS ----------------- setState
ip -------------------------- ethernet
show
port ----------------------- blocked
extDist
name
speed