1/2
This information may not, in whole or in part, be copied, photocopied,
reproduced, translated or reduced to any electronic medium or machine-
readable form without the prior written consent of Hatteland Technology
AS. The products may not be copied or duplicated in any way.
Dimensions might be shown with or without decimals and indicated as mm [inches]. Tolerance on drawings is +/- 1mm. For accurate measurements, check relevant DWG fi le.
DATASHEET
Hatteland Technology AS | www.hattelandtechnology.com | Enterprise no: NO974533146
Quick Start guide
IND105044-1 - Rev 05 - 05 Mar 2021 - PID 8370/363
2/2
Wall Mounting
Ceiling Mounting
50
80
Ø
3 x 9
Bracket drill-hole
template Cut-out
For Bullet Camera
1:1
LD-001
The ethernet cable and RJ45 connector will pass
through the openings in the RJ45 Coupler.
1. Loosen M4 screw
2. Loosen M6 screw
3. Rotate camera into desired position.
4. Tighten M6 screw (Max 9Nm)
5. Tighten M4 screw (Max 5Nm)
1
2
3
4
5
6. Insert M20 Bolt into the
Camera bracket
6
7. Place M20 Washer onto
M20 Bolt.
8. Place M20 Nut onto bolt
and tighten (Max 50 Nm)
Mounting HT FBVF xA-X1/ HT ZB2X xA-X1
7
8
