page - -
4. Use one of the adjusting screws in counterclockwise rotation to lift the lower pressure roll until the
adjust plate has contact to the upper pressure roll. ( detail .)
detail .
. Now use the other adjusting screw in counterclockwise rotation to lift the lower pressure roll until
this side of the adjust plate has contact to the upper pressure roll. (detail .)
detail .
. After correct adjust of both sides, pull out the plates.
Possible Errors:
Less pressure – The pressure rolls are free, you see a gap above the adjust plate.
Too much pressure – The pressure rolls are fixed. It is not possible to pull out the ad-
just plate.
. Press down lever. Now you have the right pressure for mounting with this thickness of mounting
plate.
Notice
Please repeat this for mounting plates with other thickness. If not you damage your
print (because of less pressure for mounting) or the laminator springs (too much pres-
sure).
