Embest Technology
Copyright © 2014 Embest Technology RIoTboard LCD8000-70T Quick Start Guide
5
nfc clock : 24000000Hz
Board: i.MX6DL/Solo-SABRESD: unknown-board Board: 0x61011 [POR ]
Boot Device: MMC
I2C: ready
DRAM: 1 GB
MMC: FSL_USDHC: 0,FSL_USDHC: 1,FSL_USDHC: 2,FSL_USDHC: 3
In: serial
Out: serial
Err: serial
Net: got MAC address from IIM: 00:00:00:00:00:00
----enet_board_init: phy reset
FEC0 [PRIME]
Hit any key to stop autoboot: 0 (
Hit any PC key to enter U-boot
)
MX6Solo RIoTboard U-Boot >
5
）
Set the display mode
Under the u-boot, 7-inch LCD display mode can be set by executing the
following instructions:
MX6Solo RIoTboard U-Boot >
setenv bootargs console=ttymxc1,115200
init=/init nosmp video=mxcfb0:dev=lcd,7inch_LCD,if=RGB565
video=mxcfb1:off fbmem=10M vmalloc=400M androidboot.console=ttymxc1
androidboot.hardware=freescale calibration
MX6Solo RIoTboard U-Boot >
saveenv
6
）
Set the touch screen
Ubuntu
a)
On entering the system, the following command can be used to unload
synaptics driver
root@linaro-ubuntu-desktop:~#
sudo apt-get remove
xserver-xorg-input-synaptics
b)
Input the following instructions to install tslib
root@linaro-ubuntu-desktop:~#
sudo apt-get install
xserver-xorg-input-tslib libts-bin
At the execution of this command, network needs to be connected. In
additional, you can download
ubuntu-touchscreen.zip
from Embest
website to install
tslib
. On unzipping, copy to U-disk and connect
