mPanel v1 User Manual
Page
11
¾
For Ethernet cabling, follow standard Ethernet cabling specifications. Allow at least 6"
slack to the cable. Plug in the Ethernet to the mPanel.
¾
If you are using direct power, plug in the 12-19VDC to mPanel.
¾
Push the mPanel into the wall and tighten the 4 screws in each corner to secure the panel
in place, do not use a power screwdriver.
¾
Turn on the power by plugging in the Ethernet connector on the PSE (POE HUB), or turn
on the direct power depending on your wiring.
¾
Install the plastic faceplate to the panel by aligning the two guide pins. Once aligned the
magnets on the face plate will keep the faceplate tight to the wall.
Start Up and Configuration
¾
By default, mPanel is configured to use DHCP (Dynamic Host Configuration Protocol).
That is, it will automatically acquire an IP address from your network router.
¾
Within approximately 60 seconds of power up, mPanel will automatically boot to the
mPanel user interface.
