Nighthawk Pro
www.emaxmodel.com
９
Mode Selections
（
1
）Please select "
Mode Selection
①
Modes: ARM, ANGLE, HORIZON, MAG, HEADFREE, HEADADJ, BEEPER, OSD SW, etc... Some modes
will not appear unless sensor is connected. Ex: If barometer is not connected to the flight controller, the altitude
mode will not display in the list.
②AUX Channel Select for Modes.
（2）AUX Channel for Modes: Select desired AUX channel for mode, then check the box and save the setting
by click the "SAVE" at right bottom corner. When mode is selected by switch the AUX channel, selected
mode name will highlighted green, other will highlighted red on the screen.
Red LED (Mode indictor) will lit. Some mode need to be select at the same time to function correctly.
RTF mode selection diagram (ARF no need)
SWB switched to position 1 is ANGLE. Position 2 is HORIZON and 3 is MANUAL. Please refer to the diagram below.
Note: We suggest donot select MAG to avoid the big current interference to compass.
Copter Testing
Please make sure to REMOVE PROPELLERS before perform ESC Calibration
！
（1）Connect receiver and flight controller
（2）Please select "Raw Sensor Data"
（3）Rotate copter to check all sensor are correct (sensor data should change according to copter
rotation)
（4）Please select "Motor Testing"
（5）Turn on transmitter
（6）Connect battery to power on the copter
（7）
Use transmitter to arm motor, flight controller light indicator will turn green. Arm and disarm motor are shown
below (Mode 2 transmitter as example below)
