MAINTENANCE OF THE LIGHTS P6
Figure 12
Figure 13
Figure 14
Figure 15
6. MAINTENANCE OF THE LIGHTS
1. Do not leave the lights “on” above water for longer than 1 minute.
2. Before switching on the lights, check whether the lights are fully submerged under water and the circuit boxes
are running properly.
3. This unit does not need any kind of maintenance. If it is not working properly, please contact EMAUX
authorized dealer where you purchase the unit from.
4. Warranty will be voided if the Emaux Under water Light was dismantled by unauthorized personnel.
Mounting plate
O-ring
Nut
Figure 9
Figure 10
Figure 8
2X24
147,5
2X24
110
P100/CP100
TP100
TP100
NS75/150
Figure 11
C)
1) Clean the O-ring installation position and put the O-ring. (Figure 12)
2) After install the O-ring. Put the transparency lid and then put the cover. (Figure 13)
3) While install the cover with the base, please to note that the sign of “ TOP”from the base should meet with the
sign of “ TOP“ for the cover. (Figure 14)
4) Rotate to the station position and then to use screw driver that to tighten. (Figure 15)
5) For Unassembled, please to reverse the sequence.
Assembly for CP100
UL-TP100
Key No.
Part No.
Description
Qty
1*
01221003
Colour lens (Red+Green+Blue) for P100, DP100
1
2
01051259
Face Plate for TP100
1
3
03011307
M4*12 Screw
1
4
01040211
Lights Lens
1
5
02021055
O-Ring for TP100
1
6
E040205
Halogen high Bulb (Yellow Light)
1
7
89040402
UL-TP100 Lights Body Set
(
with 2.5M cable and socket)
1
8
03011331
M4*12 Screw
8
9
03011332
M4*16 Screw
2
10
01012005
TP100 Lights Bracket
1
11
89040401
TP100 Lights Vinyl Pool Fitting
1
12
89040501
TP100 Lights Concrete Pool Fitting
1
Note:
*
UL-TP100 Light Colour Lens 1 set (Red+Green+Blue)
9
4
1
2
3
5
6
8
7
10
P9 SPARE PART LIST
Vinyl
Pool
11
Concrete
Pool
12
B) Fiberglass Pools / Vinyl Pools Installation
1
Refer to section"Preparing to Install".
2) Make 2 holes on the pool wall (Figure 8).
3) Place the o-rings between the Mounting Plate and the pool wall and tighten it with the Nut on the other side of
the pool wall (Figure 9).
4) Put the cable sequentially through the sealing Nut, the sealing O-ring and the cable hole on the mounting plate;
then tighten the Nut (Figure10).
5) Wrap extra cables behind the light to make sure it could be taken to the pool surface for future maintenance.
Then, hang the light onto the Mounting Plate and tighten the screws (Figure 11).
)
