7
GB
•
To reposition the saw, repeat the same
sequence of operations.
With the EMAK professional pruner, branches of
all shapes and sizes are rendered accessible for
cutting back or thinning; the operator need only
select a safe stance and pole angle, and most of
the cutting can be done while standing on the
same spot.
When cutting low branches near the gr
ound,
be certain the chain does not make contact
with stones or soil.
When pruning high branches, take up a safe
position below and avoid standing directly
under the branch being cut.
DO NOT USE LADDERS, AND DO NOT CLIMB
INTO TREES
DESCRIPTION OF COMPONENTS
1 -
BAR
2 - CHAIN
3 - OIL FILLER CAP
4 - OIL TANK
5 - BAR CLAMP NUTS
6 - CHAIN GUARD
7 - CHAIN ADJUSTMENT SCREW
8 - ADJUSTABLE BEVEL DRIVE
9 - BEVEL DRIVE LOCK / RELEASE SCREW
SAFETY INSTR
UCTIONS
The EP120 / EP120EF pruner can be attached
only to machines with rigid or telescopic poles
made by EMAK.
Always switch off the engine of the pruner when
preparing the work area.
Fit the chain sheath when transporting the
machine.
1 The information given here must be read with
care.
2 Do not use the pruner near overhead power
lines, as there is a risk of electric shock.
DO NOT OPERA
TE THE PRUNER WITHIN
10 METRES OF ELECTRIC POWER LINES.
Make certain animals or bystanders are
kept at a distance of at least 15 metres, as
the reach of the pruner could place them at
risk.
3
Do not elevate the pole to an angle greater
than 60° from the ground.
4 Do not use ladders or stand precariously, and
keep the work area clean and tidy to allow a
swift exit if necessary. Never climb into trees
with the pruner; if extra height is needed, a
hydraulically operated overhead access
platform must be used.
BAR AND CHAIN ASSEMBL
Y
The EMAK pr
ofessional pruner is supplied with
bar and chain factory fitted and adjusted.
To replace the bar and chain, proceed as follows:
1 Loosen the two lock nuts (A) and remove the
chain guard (B).
2 Seat the chain in the groove (C) of the bar and
over the drive sprocket (D); first, viewing the
assembled bar and chain, make certain that
the chain is fitted with the cutting edges facing
in the clockwise direction (E).
3 Position the guard, keeping it tight against the
bar, then tighten the tensioner screw (H) so
that the chain tension pin (F) engages the hole
(G) in the bar.
4 Snug the nuts (A) against the guard, without
tightening fully. Turn the chain tensioner screw
(H) clockwise; check the tension of the chain,
ensuring that when lifted, the inside of the link
is just visible for about 4 mm.
The adjustment will be correct when the chain
runs freely on the bar.
Tighten the lock nuts (A).
INST
ALLATION OF EMAK EP120 /
EP120EF PROFESSIONAL PRUNER
1
Couple the bevel drive to the drive shaft.
2 Align the side screw of the bevel drive with the
hole located at 33 mm approx from the end of
the pole tube.
3 Fit the screw (A) anchoring the bevel drive to
the hole in the pole tube, and tighten
moderately so that the screw engages the
hole.
Tighten the screws (B) gradually, in alternating
sequence, using the 4 mm key provided. The
B
C
D
E
