
154
Chapter 5
Clearing Password Check and BIOS Recovery
This section provides you with the standard operating procedures of clearing password and BIOS recovery for
eMachine HM50-MV. The machine provides one Hardware Open Gap on main board for clearing password
check, and one Hotkey for enabling BIOS Recovery.
Clearing Password Check
Steps for Clearing BIOS Password Check
If users set BIOS Password (Supervisor Password and/or User Password) for a security reason, BIOS will ask
the password during systems POST or when systems enter to BIOS Setup menu. However, once it is
necessary to bypass the password check, users need to short the HW Gap to clear the password by the
following steps:
1.
Power Off the system, and remove HDD, AC and Battery from the machine.
2.
Open the back cover of the machine, and remove the Modem Board (see “Removing the DIMM Modules”
on page 55.
3.
Disconnect the RTC Battery cable and locate the J1 jumper.
4.
Use an electric conductivity tool to short the two points of the HW Gap.
5.
Plug in AC, keep the short condition on the HW Gap, and press Power Button to power on the system till
BIOS POST finish. Then remove the tool from the HW Gap.
6.
Restart system. Press
F2
key to enter BIOS Setup menu.
7.
If there is no Password request, BIOS Password is cleared. Otherwise, please follow the steps and try
again.
NOTE:
These steps are only for clearing BIOS Password (Supervisor Password and User Password).
Clear CMOS Jumper
Item
Description
Location
J1
Clear CMOS Jumper
Thermal Module Bay, under Modem Board
Содержание HM50-MV
