trouBleshootIng
All leds are permanently off
This indicates a problem with the supply voltage. Please verify
that the voltage is in the range of 100-240 VAC. If the problem
persists, the product may be malfunctioning. Please contact
Elvaco for support.
red led is permanently on
This indicates an error on the M-Bus. Please verify that there
is no short-circuit. The voltage should be in the range of 24-30
VDC.
cannot connect to the product using tcP/IP
Please use the web interface to verify the following TCP/IP
settings:
•
TCP port used for communication.
•
IP address.
•
Ethernet link settings.
cannot read connected M-Bus meters
Please verify that:
•
Voltage on the M-Bus is in the range of 24-30 VDC.
•
All connected M-Bus meters use a unique primary or
secondary address (depending on the addressing mode).
•
The baud rate used is supported by meters. The baud
rate can be configured in the M-Bus Serial section of the
web interface.
Product
Part number
Description
CMe3000 1050015
M-Bus Gateway for Fixed Network
contAct InForMAtIon
elvaco AB technical support:
Phone: +46 300 434300
E-mail: support @elvaco.com
Online: www.elvaco.com
technIcAl sPecIFIcAtIons
Mechanics
Protection class
IP20
Mounting
Mounted on DIN-rail (DIN 50022) 35 mm
Electrical connections
Supply voltage
Screw terminal. Cable 0.75-2.5 mm², 0.5
Nm tightening torque
M-Bus master port
Pin terminal. Solid wire 0.6-0.8 Ø mm
Electrical characteristics
Nominal voltage
100-240 VAC (+/- 10%)
Frequency
50/60 Hz
Power consumption (max) <2.5 W
Power consumption (nom) <1 W
Installation category
CAT 3
User interface
Green LED
Power
Red LED
Error
Yellow LED
Network status
Push button
Factory reset
Configuration
Web interface
Integrated M-Bus Master
M-Bus baud rate
300 and 2400 Bit/s
Nominal voltage
28 VDC
Maximum unit loads
8T/12 mA (can be extended with
CMeX10-13S Series)
Maximum cable length
1000 m (100 nF/km, maximum 90
Ω
)
Approvals
EMC
EN 61000-6-2, EN 61000-6-3
Safety
EN 61010-1, CAT 3
orderIng InForMAtIon
CMe3000 Quick manual
Document id: 1090113
Version: 1.0
