INTRODUCTION
CMe2100 LTE is a flexible and cost-effective DIN-mounted M-Bus
Metering Gateway for Mobile Network. It is compatible with all meters
following the M-Bus standard. For a complete description of the
product, visit the Elvaco AB website, www.elvaco.com.
OVERVIEW
CMe2100 LTE
M-Bus Metering Gateway for mobile network
MOUNTING
The CMe2100 LTE should be mounted on a DIN-rail. The plastic clip on
the bottom is used to mount and demount the unit from the DIN-rail. For
safety reasons, a DIN-rail enclosure must cover the terminals.
SIM CARD
Install the SIM card into the SIM card holder (10). Remember the phone
number for later use.
IMPORTANT
•
The SIM card shall not have any PIN code activated.
•
The SIM card must have 2G/3G/LTE internet access activated for
full functionality.
•
If a prepaid SIM card is used, ensure that enough credits are
available.
POWER SUPPLY
The installation should be performed by a qualified electrician or installer
with required knowledge. The power supply should be connected via
a clearly marked, easily accessible and close switch so the unit can be
switched off during service work. The main supply should be connected
to screw terminal (13) and (14). Main supply voltage should be in the
range of 100-240 VAC, 50/60 Hz.
M-BUS 2-WIRE BUS
M-Bus is a multi-drop 2-wire bus with no polarity. Use a cable of area
0.25-1.5 mm
2
, e.g. a standard telephone cable (EKKX 2x2x0.5). Connect
the wiring to the connector (3). Do not exceed the maximum cable
length of 1000 m.
ANTENNA
An external antenna is needed for CMe2100 LTE, this is ordered
separately. Please visit www.elvaco.com to find a suitable antenna option.
The antenna should be connected to the SMA connector (4). If the unit
is mounted in a metal cabinet, the external antenna should be mounted
outside the metal cabinet.
IMPORTANT
•
CMe2100 LTE should be connected to the antenna when the
antenna wiring is done. Otherwise the SMA connector can be
damaged.
•
Do not mount the antenna close to the M-Bus 2-wire bus.
•
Do not mount the antenna inside a metallic cabinet.
INSTALLATION/SEND SMS COMMAND
CMe2100 LTE is configured with SMS commands. Send any command
from the table below in a text message to the phone number of the
product.
Function
SMS command
New installation of meter
install n [profile]
Change of meter
install n [profile] clean
Add meter on the bus
install n [profile] keep
Signal strength/is the terminal alive? status
Is mobile data working?
timesync
Send momentary values via e-mail
momreport
Send momentary values to a specific
recipient
momreport email.to=name@
domain.se
Receive meter values via sms
momreport 101 [secondary
address]
Receive meter values as excel files
report 1day 1104 email.
[email protected]
Receive hourly values once every
day as excel files
sch report1 1day 1104
1.
Serial number
2.
Push button
3.
M-Bus connector
4.
Antenna SMA connector
5.
IR interface
6.
Status LED (green)
7.
Error LED (red)
8.
Network LED (yellow)
9.
Blue LED (not used)
10. SIM card holder
11. USB slave connector
12. USB master connector
13. Power supply L
14. Power supply N
IMPORTANT
The product handles up to 256 meters. Use an M-Bus extender for
installations with more meters than the product limit.
All connected M-Bus slaves must have unique primary or secondary
M-Bus addresses depending on addressing mode.
