7
3.2. Sensor addressing
Each sensor in the weather monitoring system is
assigned an address which enables the receiver to
integrate the sensor trouble-free into the system.
The factory setting for each sensor is address 1. Eight
addresses are available (1 to 8, corresponding to the
display).
You can carry out addressing yourself using the
jumpers on the sensor circuit board.
To do that, the protective cap must first be taken off of
the sensor housing and the batteries removed.
You then remove the two screws on the back which are
on the left and right of the wall holder, remove the screw
above the battery compartment, and take off the front
half of the housing.
Undo
screw
Undo
screw
Undo
screw
