Fixture Version
To select Fixture Version, press the
ENTER
button to confirm, firmware
version will show on the display. To go back to the
functions without any
changes press the
MENU
button again. Press and hold the
MENU
button
for one second to go back to the main menu.
Reset
Enter
MENU
mode, select
Reset
Functions, press the
ENTER
button to
confirm. Use the
UP/DOWN
buttons to select Pan/Tilt, Colour, Gobo, Prism,
Iris, Focus or All. To go back to the
functions without any changes press the
MENU
button again. Press and hold the
MENU
button for one second to
go back to the main menu.
3.4 Home Position Adjustment
Press the
MENU
button, then press and hold the
ENTER
button for about 3
seconds to go into the
offset
mode to adjust the home position. Use the
UP
and
DOWN
buttons to choose the submenu, press the
ENTER
button to
confirm and then it will go back to the previous menu automatically. Press the
MENU button to exit.
Menu
Pan offset
-127 - 127
Tilt offset
-127 - 127
Colour offset
-127 - 127
Gobo offset
-127 - 127
Prism offset
-127 - 127
Focus offset
-127 - 127
4. Control By Universal DMX Controller
4.1 DMX 512 Connection
4.1.1. In last unit, the DMX cable has to be terminated with a terminator.
Solder a 120 ohm 1/4W resistor between pin 2(DMX
‐
) and pin 3(DMX+) into
a 3-Pin XLR
plug and plug it in the DMX
output of the last unit.
4.1.2. Connect the units together in a `daisy chain` using the XLR plug
from the output of the unit to the input of the next unit. The cable can not
branched or split to a `Y` cable. DMX 512 is a very high-speed signal.
Inadequate or damaged cables can easily corrupt the signal.
4.1.3. The DMX output and input connectors are a pass-through type to
maintain the DMX circuit, when power is disconnected to the unit.
4.1.4. Each lighting unit needs to have an address set to receive the data
sent by the controller. The address number is between 0-511 (usually 0 & 1
are equal to 1).
4.2 DMX Address Setting
If you use a universal DMX controller to control the units, you have to set
DMX address from 1 to 512 so that the units can receive DMX signal.
Press MENU button to enter the menu mode, select DMX Functions, press
the ENTER button to confirm, use the UP and DOWN buttons to select DMX
Address, press the ENTER button to confirm, the present address will blink
on the display, use the UP and DOWN buttons to adjust the address from 0
to 512, press the NTER button to store. Press and hold the MENU button for
one second to go back to the main menu.
Please refer to the following diagram to address your first 4 units:
Channel Mode
Unit 1
Unit 2
Unit 3
Unit 4
15 channels
1
16
31
46
5.3 DMX512 Configuration
15 Channels Mode:
Channel Value
Function
1
0-255
Pan
2
0-255
Pan fine
3
0-255
Tllt
4
0-255
Tilt fine
5
0-7
White
