Elumen8 9RE Beam, Руководство пользователя

Страница: 12 / 32

www.prolight.co.uk 9RE Beam User Manual
12
Lamp Adjustment
Lamp adjustment:
The lamp holder is aligned at the factory. Due to slight differences between lamps, the fine adjustment
of a lamp may improve the light performance.
For lamp adjustment please use the 4 screws on the lamp assembly plate marked C and the adjustment
screw marked D.
To adjust the lamp in the fixture:
1. Connect the fixture to the mains and switch on the lamp, open the shutter (strobe) and dimmer and
set the focus. Colour wheel and gobo wheel should be open and check the image on the wall.
2. Disconnect the fixture from the mains.
3. Loosen the 2 screws (1) labelled A and B on the lamp cover and remove. Then loosen the 4 screws in
the top head shell (3) and remove to access the lamp compartment.
4. Loosen the 4 screws on the lamp assembly plate labelled (C).
(Do not remove these totally, a half turn will suffice.)
5. Move the lamp into the required position (left/right) by using a suitable flat headed screwdriver
inserted into the adjustment screw labelled D and rotate clockwise (lamp moves left)/anti-clockwise
(lamp moves right) until the lamp has been adjusted to your requirements.
6. Tighten the 4 screws on the lamp assembly plate (C).
7. Re-insert the head shell and tighten the 4 screws (3). Then re-insert the lamp cover (2) and tighten
the 2 screws (1) labelled A and B on the lamp cover.
8. Connect the fixture to the mains and check the adjustment is now correct.
9. If the fixture needs further adjustment repeat steps 2-8.
Please note: If you need to adjust the lamp up/down please use the gobo offset adjustment on page 22.
Image on the wall
Centred Lamp
The lamp MUST be adjusted with the fixture disconnected from the mains!
Do not operate this fixture without all external covers!
C
C
C C
D