ELTRA CSi/d, Руководство пользователя

Страница: 13 / 38

Installation
13
4.4 Switching to manual mode
Manual mode can be used to switch through the individual steps of the CSi/d Autoloader.
Fig. 3: Manual mode
Number Component Description
1
Button for manual control
Used to switch through the individual steps in
manual mode
2
Electrical connection safety
circuit
If the power supply unit of the CSi/d Autoloader
is plugged in there, the safety circuit is bridged
To switch to manual mode the CSi analyzer must be turned off and connected to the CSi/d
Autoloader. Proceed as follows:
1.

Pull the power supply unit from the back of the CSi/d Autoloader.
2.

Keep the manual control button ( 1 ) pressed and plug the power supply unit
into the designated electrical connection ( 2 ) in the safety circuit (see Fig. 3:
Manual mode).
3. Keep the manual control button ( 1 ) pressed for a few seconds (see Fig. 3:
Manual mode).
Manual mode has now been activated and the individual steps can be activated using the
manual control button (
1 ).
Switching to manual mode bridges the safety circuit.
Remove the power supply unit to exit manual mode.
1
2