WOP-2L. User manual
40
•
•
•
•
•
•
Static
– operation mode where IP address and all the necessary parameters for WAN interface are
assigned statically. If 'Static' is selected, the following parameters will be available to set:
Static IP
– device WAN interface IP address in the provider network;
Netmask
– external subnet mask;
Gateway
– address, to which the packet is sent, if the route in routing table is not found for it.
Primary DNS server, Secondary DNS server
–
IP address of DNS servers. If DNS servers' addresses are
not allocated automatically via DHCP, set them manually.
To apply a new configuration and save setting to non-volatile memory, press 'Apply'. Press 'Cancel' to discard the
changes.
5.7.2 The 'Access' submenu
In the
'Access'
submenu, you can configure access to the device via the web interface, Telnet, SSH, NETCONF and
SNMP.
To enable access to the device via the web interface via HTTP protocol, set the flag next to 'WEB'. In the
window that appears, it is possible to change the HTTP port (by default, 80). The range of acceptable values
of ports, in addition to the default, from 1025 to 65535 inclusive;
