WOP-2ac-LR2. User manual
32
•
•
•
•
•
•
•
•
•
•
•
•
•
cwMax
– the maximum timeout value before resending a frame, specified in milliseconds, takes
the values 1, 3, 7, 15, 31, 63, 127, 255, 511, 1023. The value of cwMax must exceed the value of
cwMin;
TXOP Limit
– this parameter is used only for data transmitted from the client station to the access
point. The transmission capability is the time interval, in milliseconds, when the client WME station
has the rights to initiate data transmission over the wireless medium to the access point, the
maximum value is 65535 milliseconds;
Station EDCA parameters
– table of client station parameter settings (traffic is transmitted from the
client station to the access point). For description of table fields, see above.
To apply a new configuration and save setting to non-volatile memory, press 'Apply'. Press 'Cancel' to discard
the changes.
4.7 The 'VAP' menu
In the 'VAP' menu, you configure virtual Wi-Fi access points (VAP).
4.7.1 The 'Summary' submenu
The 'Summary' submenu displays the settings of all VAPs. You can see the settings of each virtual access
point in sections VAP0..3.
VAP0..3
– the sequence number of the virtual access point;
Enabled
– when checked, the virtual access point is enabled, otherwise it is disabled;
Security mode
– the type of data encryption used on the virtual access point;
VLAN ID
– VLAN number from which the tag will be removed when transmitting Wi-Fi traffic to clients
connected to this VAP. When traffic flows in the opposite direction, untagged traffic fr
о
m clients will be
tagged with VLAN ID (when VLAN Trunk mode is disabled);
SSID
– virtual wireless network name;
Broadcast SSID
– when checked, SSID broadcasting is on, otherwise it is disabled;
VLAN Trunk
– when the flag is set, tagged traffic is transmitted to the subscriber;
General Mode
– when the flag is set, transmission of untagged traffic jointly with tagged traffic is
allowed (available when Trunk VLAN mode is enabled);
General VLAN ID
– a tag will be removed from the specified VLAN ID and the traffic of this VLAN will
pass to the client without a tag. When traffic passes in the opposite direction, untagged traffic will be
tagged with General VLAN ID;
Station Isolation
– when checked, traffic isolation between clients in the same VAP is enabled.
To apply a new configuration and save setting to non-volatile memory, press 'Apply'. Press 'Cancel' to discard
the changes.
