ELTEX R45 Series, Руководство по эксплуатации

Страница: 8 / 20

8
BA-en-2045-1808_R45
2.4 Contact protection
As the site of installation and/or use of the units is outside the control of
Eltex, contact protection against inadvertent contact by personnel as
specified by the employers’ liability insurance association (e.g. DGUV V3
in Germany) may have to be provided.
Contact protection made of conductive material must be grounded.
2.5 Inspection of the protective resistors - contact protection
The function and the appearance of the protective resistors must be
inspected at regular intervals. The inspection intervals are specified in the
accident prevention regulations, as amended (e.g. in Germany DGUV
V3). Eltex recommend inspection intervals of 6 months.
The function of the series resistors must be checked using a suitable
measuring device. The test voltage must be 1,000V. The measured resist-
ance between the high-voltage connection and the individual emission tip
must not fall below 10.8 MOhm and not exceed 13.2 MOhm.
2.6 Technical advance
The manufacturer reserves the right to make changes to the technical
specifications without prior notice in order to adapt the units to state-of-
the-art engineering. Eltex will provide the latest information on any
changes or modifications in the operating instructions on request.
3. Installation and assembly
3.1 Assembling the discharging bar
The series R45 discharging bar is attached to the machine via the oblong
holes in the cover caps. Alternatively, the bar can be attached using
mounting clamps. Fig. 2 shows the bar with the mounting clamps and the
required installation distances.
Depending on use, other attachments and fittings (e.g. threaded holes in
the machine wall) are also allowed.
Warning !
In applications involving moving bars (e.g. film draw strips), the high volt-
age cable must be attached such that there is no cable movement near
the connection zone of the power supply unit.