NTU-52V/VC. User manual (user)
32
•
•
•
•
•
•
5.3.4 The 'UPnP' submenu. Automated Setup of Network Devices
In this section you can configure Universal Plug and Play (UPnP™) function. UPnP ensures compatibility with
network equipment, software and peripheral devices.
Services
→
UPnP
UPnP (Enable/Disable)
– enable/disable the UPnP function;
WAN Interface
– WAN interface on which the UPnP function will operate;
To save the settings, click the 'Apply Changes' button.
5.3.5 The 'RIP' submenu. Dynamic routing configuration
This section is used to select the interfaces on your device is that use RIP, and the version of the protocol
used. Enable the RIP if you are using this device as a RIP-enabled Device to communicate with others using the
Routing Information Protocol.
Services
→
RIP
RIP (Enable/Disable)
– enable/disable the use of dynamic routing protocol RIP;
To accept and save the settings, click the 'Apply Changes' button.
Interface
– interface on which RIP will be started;
Receive Mode
– incoming packets processing mode (NONE, RIP1, RIP2, both);
Send Mode
– sending mode (NONE, RIP1, RIP2, RIP1 COMPAT).
The use of UPnP requires NAT setup on an active WAN interface.
