4
Elterm M.M.Kaszuba Sp.J., ul. Przemysłowa 5, 86-200 Chełmno
www.elterm.pl
Device schematics:
1.
Thermic switch
2.
Reset
(of thermic switch)
3.
Heat block
4.
Temperature sensor
5.
Flowmeter
6.
Triac
7.
Connecting block
8.
Thermic safety fuse
9.
Hot water outlet
10.
Cold water inlet
Electric schematics:
Device installation - remarks:
The installation must only be carried out by qualified installer and installed in accordance to all national
and local electrical and plumbing regulations.
1.
Make sure the device is not mechanically damaged and complete.
2.
Do not install in premises where temperature falls below 0°C.
3.
Compare your installation with device requirement (power allocation, supply voltage, water pressure,
earth, wires cross section, proper fuses both over-current and differential-current, etc.).
4.
Device needs to be earthed!
5.
Main power circuit needs to be protected both over-current and differential-current fuses.
6.
Do not install close to strong magnetic field.
7.
In case of longer idle time of device, power supply needs to be disconnected.
8.
We highly recommend fitting an isolation valve and ball valve before the unit to close system before
removal of the tap and servicing.
